Yeastar Technology NeoGate TG800 Manual de usuario Pagina 47

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 56
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 46
NeoGate TG Series User Manual
http://www.yeastar.com 47/56
Description
Where to get the caller ID in SIP packet
Where to get the DID in SIP packet
It is set when the telecom provider needs.
Usually it is not needed
Whether send Remote-Party-ID on SIP header.
Default no.
Whether allow anonymous registration
extension. Default: no. Its recommended to be
disabled for security.
Enable pedantic parameter. Default: no.
If enabled, when NeoGate TG rejects “Register”
or “Invite” packets, NeoGate TG always
respond the packets using “SIP404 NOT
FOUND”. Its recommended to be enabled for
security.
Enable session-timer mode, default: yes. If you
found the call is cut off every 15 minutes every
time, please disable this.
The max refresh interval
The min refresh interval, which mustn't be
shorter than 90s
Choose session-refresher, the default is Uas
7.2.4 IAX Settings
IAX is the Internal Asterisk Exchange protocol, you can connect to NeoGate TG or register
IAX trunk to another IAX server. Its supported by the asterisk-based IPPBX.
Figure 7-26
Items
Description
Bind Port
Port used for IAX2 registrations. Default is 4569.
Bandwidth
Low/medium/high with this option you can control
which codec to be used.
Vista de pagina 46
1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 55 56

Comentarios a estos manuales

Sin comentarios